Arc Welding




                       A SAFETY TALK FOR

                      DISCUSSION LEADERS



This safety talk is designed for discussion leaders to use in preparing safety

meetings.



Set a specific time and date for your safety meeting.  Publicize your meeting

so everyone involved will be sure to attend.



Review this safety talk before the meeting and become familiar with its

content. Make notes about the points made in this talk that pertain to your

workplace.  You should be able to present the material in your own words and

lead the discussion without reading it.



Seating space is not absolutely necessary, but arrangements should be made so

that those attending can easily see and hear the presentation.



Collect whatever materials and props you will need ahead of time.  Try to use

equipment in your workplace to demonstrate your points.





                      DURING THE MEETING



Give the safety talk in your own words.  Use the printed talk merely as a

guide.



The purpose of a safety meeting is to initiate discussion of safety problems

and provide solutions to those problems.  Encourage employees to discuss

hazards or potential hazards the encounter on the job. Ask them to suggest ways

to improve safety in their area.



Don't let the meeting turn into a gripe session about unrelated topics.  As

discussion leader, its your job to make sure the topic is safety.  Discussing

other topics wastes time and can ruin the effectiveness of your safety meeting.



At the end of the meeting, ask employees to sign a sheet on the back of this

talk as a record that they attended the safety meeting.  Keep this talk on file

for your records.





Arc Welding



Do you know the dangers associated with arc welding equipment? Do you know

how to identify hazards related to your operation?

Most arc welding equipment is designed to operate safely in high humidity,

rainy and windy weather, and in the presence of vapors, corrosive fumes, dirt,

dust and gases.



Wet equipment or wet welders can spell disaster. Wet equipment should be dried

off, but only AFTER the power source has been disconnected.  Before using

welding cables, check the insulation and lead cables for exposed conductors.



Replace all weld lead spliced within lO feet of the holder.

To reduce the chance of shock, check the electrode holders for loose or exposed

connection.



If metal, inert-gas-shield welding is used, examine the gas hose for leaks.

Never coil or loop electrode cable around any part of your body.



Be sure the welding machine frame is properly grounded; double-check the ground

connections.



Never use pipelines carrying gases or flammable liquids or conduits carrying

electrical conductors as grounds. Don't ground to a building structure that is

a great distance from the weld.



Wet floors are dangerous and can cause electrical shock. Special precautions

must be taken.



Make sure the insulation is sufficient on higher open-circuit voltage.

If you are AC welding under wet conditions, including perspiration, be sure to

have an automatic control to reduce the no-load voltage; this prevents

electrical shock.



Do not change the polarity switch when your machine is under load. Arcing

because of high current can burn the switch contact surface and can seriously

burn you.



Make sure there is a power disconnect switch on the welding machine; never use

a machine without one. This switch shuts down the machine immediately in an

emergency.



Electrode holders should be stored where they cannot make contact with

personnel, conductors, fuels or compressed gas tanks.



If you are not going to be welding for a few minutes, disconnect the power

source and remove the electrodes.



Never strike an arc on an industrial gas cylinder. Always keep electrodes and

their holders and any other live parts away from gas cylinders.



Note to Discussion Leader:



If there have been welding accident in your area, be prepared to discuss them

with your employee. Listen to their ideas; they may have the answer you have

been looking for. Also, mention any hazards that are unique to your particular

operation.

Text Version